CAN Convertor RPM Installation
Identify your RPM output variant, use the 12-pin wiring reference, and verify the readings in the web interface.
Identify your unit
Check the label on your convertor and verify the signal required by your instrument cluster. The documented Coil variant supplies a high-voltage pulse for compatible coil tachometers, such as those in Golf Mk1 and Mk2 examples. The documented Digital variant supplies a 12 V pulse for compatible clusters, such as the Golf Mk3 and Corrado examples.
High-voltage coil output. The Black/Red wire on pin 11 is for a compatible coil tachometer only. Connect and insulate it before applying power. Use your vehicle’s wiring diagram to verify the cluster and fusebox connections.
12-pin connector and wiring
Use the pin numbers and the connector orientation shown in the manufacturer’s diagram. This table describes the manual’s pinout. Output availability depends on your unit and configuration.
| Pin | Wire colour | Function |
|---|---|---|
| 1 | Orange/Black | CAN bus High input |
| 2 | Gray/Red | Output 1 · 12 V RPM pulse for compatible Mk3 and Corrado clusters |
| 3 | Blue/White | Output 2 · VSS speed signal in VSS mode |
| 4 | Brown/Blue | Output 4 · MIL light, ground-switched output |
| 5 | Brown/White | Output 5 · EPC light, ground-switched output |
| 6 | Black/Purple | Switched 12 V supply |
| 7 | Orange/Brown | CAN bus Low input |
| 8 | Yellow | Output 3 · coolant temperature |
| 9 | White | VSS speed input |
| 10 | Black/White | Input 2 · unused in the manual |
| 11 | Black/Red | Output 1 · high-voltage RPM pulse for a compatible coil tachometer |
| 12 | Brown | Ground |
CE1 and CE2 connection examples
The wire colours below refer to the vehicle side. Confirm the fusebox type and the actual wire at each position using the vehicle’s wiring diagram.
| Fusebox | Example | Signal | Position and vehicle wire |
|---|---|---|---|
| CE1 | Golf Mk1 / Mk2 | RPM | D26 · Red/Black |
| CE2 | Golf Mk2 / Mk3 | RPM | G1/12 · white connector · Green/Black or Red/Black |
| CE2 | Golf Mk3 | Speed | G1/11 · white connector · White/Blue |
| CE2 | Golf Mk2 / Mk3 | Coolant | G2/3 · white connector · Yellow/Red |
Power up and verify
- Check that the wiring is secure and insulated before applying power.
- Power the convertor and connect to its Wi-Fi web interface.
- Choose the CAN protocol for your source ECU and the RPM Output setting for the receiving cluster.
- Check engine RPM and the connection indicators on Home. If the convertor receives RPM but the tachometer reads incorrectly, check the cluster’s output type and RPM Output setting.