TECHNICAL DOCUMENTATION

SSP 335 Cornering Light System

PDFEN20 pages1 MB
SSP 335 Cornering Light System - PDF cover

This PDF is currently unavailable.

Read document text
Service TrainingSelf-study Programme 335Cornering Light SystemDesign and Function Volkswagen’s cornering light system features two new light functions: - the dynamic cornering light and - the static cornering light.Both functions improve road illumination considerably compared with conventional headlights when the vehicle is cornering and turning. This self-study programme will teach you how the cornering light system works in detail.S335_027NEWImportant NoteThe self-study programme shows the design and function of new developments. The contents will not be updated.For current testing, adjustment and repair instructions, refer to the relevant service literature.2 ContentsBrief Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4System Overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6CAN Communication . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9Dynamic Cornering Lights . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10Static Cornering Light . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12Design . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14Service . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17Test Yourself . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 183 Brief OverviewComponents and LocationsThe following diagram shows the locations of the control units and components that make up the cornering light system in the vehicle. The locations are almost identical in all types of vehicle.Cornering light and headlight range control unit J745Right-hand headlight with power output module for right headlight J668ABS control unit J104, mounted in engine compartmentLeft-hand headlight with power output module for left headlight J6674 The cornering light system has the following functions: - dynamic cornering light (swivelling dipped beam) on the road, - static cornering light, additional lights for better illumination when driving around tight curves, for example, when turning off.S335_009Steering angle sensor G85, built into the steering columnOnboard supply control unit J519, mounted behind the fuse box5 System OverviewSensors* only in vehicles without air suspension ** only in vehicles with air suspension G474 Left swivel module position sensor (type depends on manufacturer)G76 Rear left vehicle level sender* G77 Rear right vehicle level sender* G78 Front left vehicle level sender* G289 Front right vehicle level sender*G475 Right swivel module position sensor (type depends on manufacturer) G85 Steering angle senderJ745 Cornering light and headlight range control unitG44 G45 G46 G47Rear right speed sensor Front right speed sensor Rear left speed sensor Front left speed sensorJ104 ABS control unit J285 Control unit with display in dash panel insert J533 Data bus diagnostic interfaceE1 Light switchF4 Reversing light switchIn cars with air suspension, the information on the vehicle level is sent directly from the adaptive suspension control unit to the drive CAN data bus. There it can be accessed by the cornering light and headlight range control unit. On vehicles without air suspension, the control unit receives the information from the vehicle level senders.6 Control ElementsL148 Left cornering light bulbV48 Left headlight range control motorJ667 Power output module for left headlightV318 Left dynamic cornering light control motor L149 Right cornering light bulbV49 Right headlight range control motorJ668 Power output module for right headlightV319 Right dynamic cornering light control motorJ197 Adaptive suspension control unit** J220 Motronic control unit N395 Left headlight screen adjustment solenoidJ527 Steering column electronics control unitN396 Right headlight screen adjustment solenoid J343 Left gas discharge light control unit L13 Left gas discharge (xenon) bulbJ344 Right gas discharge light control unit J519 Onboard supply control unit L14 Right gas discharge (xenon) bulbM5 Front left turn signal bulbS335_010 M7 Front right turn signal bulb7 System OverviewSchematic Diagram of HeadlightsThe following section provides a schematic diagram using the right-hand headlight as an example.Terminal 15aJ519J668 J667J344* only in vehicles without air suspension ** only in vehicles with air suspensionJ745 L149 N396M7J197** L14 Terminal 31 G475 V319 V49 G289* G77*S335_029N396 G77 G289 G475 J197 J344 J519 J667 J668 J745Right headlight screen adjustment solenoid Rear right vehicle level sender Front right vehicle level sender Right swivel module position sensor Adaptive suspension control unit Right gas discharge light control unit Onboard supply control unit Power output module for left headlight Power output module for right headlight Cornering light and headlight range control unitV319 V49 L14 L149 M7Right dynamic cornering light control motor Right headlight range control motor Right gas discharge (xenon) bulb Right cornering light bulb Front right turn signal bulbColour code/legend Positive Earth Input signal CAN data busThe voltage supply for the bulbs in the static cornering light is controlled by the power output modules for the right J668 and left J667 headlights. All other bulbs in the headlights are supplied by the onboard supply control unit.8 CAN CommunicationControl Unit NetworkingG85J667 J668Steering angle sender ABS control unit Adaptive suspension control unit Motronic control unit Control unit with display in dash panel insert Onboard supply control unit Steering column electronics control unit Data bus diagnostic interface Power output module for left headlight Power output module for right headlight Cornering light and headlight range control unitS335_002 J220 J745G85J533J285J104J527J519J104 J197 J220 J285 J519 J527 J533 J667 J668 J745J197** only in vehicles with air suspension Light CAN data bus Drive CAN data busCAN data bus line Convenience CAN data bus Combi-instrument CAN data busThe picture shows the control units used for the cornering light functions and the CAN network. Data is exchanged between the control unit for headlight range control J431 and the power output modules in the left J667 and right J668 headlights via a 500 kBaud CAN (light CAN data bus). This light CAN data bus is a separate CAN data bus and is not connected to the 500 kBaud drive CAN data bus. The light CAN data bus also does not run via the diagnosis interface for data bus J533. The following variables are used as input variables for calculating the cornering light functions and are supplied to the control unit for headlight range control J431 as CAN messages. Steering wheel angle (steering angle sender G85) Steering wheel speed (steering angle sender G85) Wheel speed (ABS control unit J104) Direction of travel (onboard supply control unit J519/reversing light switch F4) Yaw velocity (ABS control unit J104) Dipped beam on (onboard supply control unit J519)You will find further information on the CAN data bus in the self-study programmes SSP 186, SSP 238 and SSP 269.9 Dynamic Cornering LightsFunctionThe dynamic cornering light system swivels the dipped beam bulb module horizontally with an integrated motor. The swivelling angle is approx. 15 degrees on the side inside the curve and 7.5 degrees on the outside of the curve.15° 7.5°7.5° 15° S335_019The different swivelling angles allow better illumination of the cornering path. The module on the inside of the curve swivels in twice as much as the module on the outside of the curve. The maximum illumination width is thus achieved with even light distribution.S335_012Lights not swivelled when vehicle is stationaryAt driving speeds under 10km/h, the bulb modules are not swivelled. Over 10km/h, the swivelling angle is basically dependent on the curve radius. The legal requirements stipulating that the headlights may be not swivelled while the vehicle is stationary are therefore fulfilled. Also, the headlights are swivelled slightly when the vehicle accelerates from a standstill.10 The Illuminated AreasThe diagram clearly shows the improved illumination of the road when the vehicle is cornering. The darker light cone represents the illumination with a conventional dipped beam. It illuminates area A of the driving lane. A large part of the light cone illuminates areas next to the road. The lighter light cone shows illumination with the dynamic cornering light, which also illuminates area B of the driving lane.S335_008 B AThe Switching On and Off ConditionsFunction Dynamic cornering lights (swivelling dipped beam) Switching on conditions - Terminal 15 on AND - Dipped beam on AND - Vehicle speed = 10km/h AND - Curve radius AND - Travelling forwards Switching off conditions - No switch-on condition11 Static Cornering LightFunctionThe static cornering light is one innovation that is clearly visible from outside the vehicle. An additional reflector has been integrated in the headlight to realise this function.S335_023 Dipped beam Static cornering lightThe top picture shows road illumination when turning off with conventional dipped beam headlights and the bottom picture with additional static cornering lights. The gain in safety brought about by the improved illumination is clear to see. The static cornering light only works in conjunction with the dipped beam headlights.S335_014S335_01512 The Halogen bulb in the additional reflector is switched on, depending on the situation, at speeds = 50km/h. They help the driver spot other road users or obstacles earlier. The static cornering light is switched on and off by dimming.S335_028The Switching On and Off ConditionsFunction Static cornering light right OR left Switching on conditions - Terminal 15 on AND - Dipped beam on AND - Driving speed = 50km/h AND - Cornering pattern (tight corners, e.g. when turning off) Switching off conditions - No switch-on condition13 DesignHeadlight Assembly (Touareg)A headlight with the cornering light function has four bulbs: 1. 2. 3. 4. The gas discharge bulb (for dipped, full beam and dynamic cornering lights), The bulb for static cornering light, The turn signal bulb and The side light bulb.Left gas discharge light control unit J343Access for changing the left cornering light bulb L148S335_016Left side light bulb M1Left gas discharge (xenon) bulb L13Left cornering light bulb L148Front left turn signal bulb M5The power output modules for the left J667 and right J668 headlights are both on the bottom of the headlight modules.Headlight lensS335_025Left gas discharge light control unit J343Power output module for left headlight J667 (screwed on underneath the headlight module)14 Dynamic Cornering Light AssemblyThe light module assembly for the dynamic cornering lights is very similar to that of a conventional Bi-Xenon module. The dipped and full beam light is contained in the bulb module. The module is mounted on bearings in a swivelling frame to allow horizontal movement. The module has an additional control motor and sensor for this. The sensor is used to recognise the swivelling angle.Mounting for left gas discharge bulb L13 Swivel frame Swivel arm Swivel axisS335_018Left gas discharge (xenon) bulb L13S335_021Left swivel module position sensor G474 Left dynamic cornering light control motor V318The gas discharge bulb is inserted in a holder at the back. The gas discharge bulb can be changed by opening the holder lid.Left gas discharge (xenon) bulb L13S335_02215 DesignThe Static Cornering LightThe static cornering light is projected outward by a reflector behind the turn signal light.S335_017The bulb in the static cornering light can be reached through an opening in the headlight module housing.S335_02616 ServiceFault IndicatorThe bulb warning light in the dash panel insert flashes when the system is faulty and the fault is stored in the fault memory of the cornering light and headlight range control unit J745.If the dipped headlights fail on one side, the cornering light function will be switched off completely. That means that the dipped beam inserts in the headlights are no longer swivelled on corners. If one dipped beam light fails, the corresponding static cornering light will also no longer be switched on.S335_024Driving Abroad on the LeftThere are two different solutions for converting the headlights for driving on the left (depending on the type of vehicle). 1. They can be switched over using a lever on the headlight bulb module. 2. Specific areas of the headlight lens can be masked. In both cases, the cornering light function needs to be deactivated with the vehicle diagnosis, testing and information system VAS 5051 or the diagnosis and service information system VAS 5052.Please refer to the electronic service information system (ELSA) for the exact procedure for converting the headlights to left-hand traffic.17 Test Yourself1. How is the improved illumination of the road on corners achieved? a) By switching on additional headlights in relation to the curve radius. b) By swivelling the dipped beam light. c) By automatically switching on the full-beam light.2.How are faults in the cornering light system indicated to the driver? a) Faults are only stored in the cornering light and headlight range control unit J745. b) Faults are not indicated. c) Faults cause the warning light in the dash panel insert to flash.3.Data is exchanged between the cornering light and headlight range control unit J745 and the power output module for right headlight J668 and left J667 via the... a) Communications line b) Drive CAN data bus c) Light CAN data bus c) Convenience CAN data bus18 4.If the cornering light and headlight range control unit J745 detects a fault in the cornering light system of the right-hand headlight, the following will occur: a) The cornering light function is switched off and both headlights are set to the straight-ahead position. b) The left-hand headlight is still swivelled while the right-hand headlight is set to the straight-ahead position. c) The vehicle lights are switched off.5.The following needs to be performed to convert the lights for driving abroad on the left: a) No need to change anything. The system recognises left-hand traffic and the conversion is automatic. b) The cornering light function needs to be deactivated using a diagnosis tester. c) Depending on the equipment, either a lever on the power output modules for the right headlight J668 and left headlight J667 needs to be moved or specific areas of the headlight lens need to be masked.5. b, c) 4. a) 3. c) 2. c) 1. a, b) Answers19 335© VOLKSWAGEN AG, Wolfsburg, VK-21 Service Training All rights and rights to make technical alterations reserved 000.2811.50.20 Technical status 10/2004❀ This paper was manufacturer from pulp thatwas bleached without the use of chlorine.