VE PRODUCT SUPPORT / INSTALLATION

Haldex Gen1 Plug and Play Installation

Install the VE controller with the inline wiring loom on a compatible Gen1 Haldex vehicle, such as a Golf Mk4 4Motion or Audi TT 8N.

VE Haldex Controller Gen1 with its inline wiring loom and connectors

Before you start

Confirm the Haldex generation and that you have the Gen1 plug and play kit before you start. This procedure uses the original Haldex connectors and the floor grommet near the spare wheel.

Use the vehicle manufacturer’s lifting and support procedure before working underneath the car.

GEN1 / INLINE LOOM

Installation

STEP 01

Access the original wiring

Lift out the spare wheel. Find the floor grommet where the factory harness exits the luggage compartment and lift it from its seat. Under the vehicle, locate the Haldex connector holder.

Haldex wiring and connector holder under the vehicle

STEP 02

Separate the factory connectors

Unclip the connector assembly from its holder. Release the connector latch and separate the original plugs to make room for the inline loom.

Close-up of the factory connector and holder

Factory plugs separated at the Haldex connection

STEP 03

Route and connect the new loom

Feed the new loom through the grommet opening from the luggage compartment. Follow the factory route to the Haldex connection and mate each new plug with its corresponding original connector.

New loom at the floor opening in the spare wheel well

New loom routed under the vehicle

Inline plugs joined to the original connectors

STEP 04

Reseat the grommet and connect the controller

Seat the grommet back in the floor opening. Check the harness routing and plug engagement, then connect the loom to the VE Haldex Controller.

Loom and grommet in the spare wheel well

VE controller connected in the luggage compartment

AFTER INSTALLATION

Connect with the app

Download the app for your phone. In the app, open Bluetooth Devices, find your Haldex Controller and select it to connect.

Haldex Controller app Bluetooth Devices screen showing a connected controller

Bluetooth Devices screen